1. It is also introduced in the principle of the stretch film packaging machine. The bag is formed by the equipment; after setting the parameters of the equipment, use the manual key in the main screen of the touch screen, and after it becomes dark, stretch the equipment. After the lower film is installed, the film is passed over each shaft by hand, and the film is pressed on the front roller by hand. Then press the film feeding button on the panel or the manual film feeding button on the lower right corner of the front roller, the equipment moves forward one step, release the hand pressed on the front roller, the film has followed the step of the equipment, Through the chain clamping on both sides, enter the next station. Press the film feed button or the manual film feed button again, and the device will run another step.
2. Press the automatic button on the main screen by hand. After it turns dark, observe whether the sealing temperature and molding temperature have reached the preset temperature, whether each protective cover has been installed normally, and whether the emergency stop switch is reset. can work automatically. Press the work button on the front panel to start working. When the film runs to the front of the sealing mold, press the stop button to stop. After confirming that the equipment is stopped, install the upper film, pass through each transmission shaft, and enter the bottom of the mold. Press the work button again. Can work continuously, press the stop button when parking.
3. After the equipment is working normally, the lower film is heated and stretched in the forming die to form the same groove as the die, and then runs forward to the discharge area to manually put the product, and then runs forward to the sealing die. Automatically vacuumize, (inflate) seal, deflate, and then run forward to the cross-cutting area, through the cooperation of the upper cross-cutting knife and the lower knife, the air bag is pressurized, and the cross-cutting knife divides each column of products horizontally, and then runs forward to the At the disc slitting knife, the slitting knife divides each product longitudinally, making it each individual product. Each product enters the subsequent process through the lower hopper. The film waste on both sides is sucked into the waste barrel through the waste suction system equipped with the equipment.
4. Due to the high-speed operation of the equipment and the up and down movement of the machine, when operating the equipment, be sure not to put hands, objects and tools into the equipment, and pay attention to the position of the hands when applying the film. When the switch is pressed, do not put your hands inside the device to avoid accidents.
